The temperature sensor has two wires which is attached to a connector. The sensor is located on the top left side (looking from rear of machine) and connected to wire harness at right side ,meeting at connector in top middle. The wires broke at the connector, on harness side, a few weeks apart. The repair has only lasted three to four weeks and then breaks again. This has happened a number of times. Does Samsung have a repair ,or advice, that can solve this problem. The machine has (VRT) vibration reduction technology. We tried running the spin cycle on low setting all the time and vibration doesnโt seem so bad but wire keeps braking. Thank you, Thomas S.
