Washing Machine Continuously Spinning/Rinsing (All Models)

[userOZ8RL6hEby]

My wife has hated this washer since we got it. Sometimes it works correctly but most often not. It runs on and on with rinse and spin for hours. I have to shut it off and usually put it on the quick wash setting to get it to finish. I saw in your notes that there might be air in the lines. No air! Also reset the machine by unplugging the power and holding the start/ pause button for ten seconds. Neither fixed this issue. She wants it thrown in the ditch but as a life long mechanic I'm sure there must be a cure? Is there any recalls on this washer on this problem? Is there a fix for this issue? Thanks, Frank Ward

[user1U1loS5YKr]

Last year we had a problem with my Samsung WA456DRHDWR/AA going out of balance and showing dc code. I couldn't finish even the smallest load. All 4 suspension rods were replaced and it worked well again until recently. It is now stopping at the spin cycle and showing dc code. On smaller loads I can adjust the clothing and the load will finish, but I'm unable to do larger loads. 

[SamsungKim1]

Can I have your email address and ticket number for your previous repair if you have it via private message?

[Bledsoe]

I've been having this same problem with my Samsung WA400PJHDWR/AA for several months, specifically, "On smaller loads I can adjust the clothing and the load will finish, but I'm unable to do larger loads." On larger loads, after I adjust the clothing it just goes back into another rinse/spin cycle and never finishes.

I've tried just putting the machine on the "Spin" (only) setting, but apparently the "Spin" (only) setting really means "Rinse + Spin" since it keeps running more water to rinse the clothes; plus it doesn't address the repeated "dc" codes.

Any assistance greatly appreciated.

[Bledsoe]

I've seen this problem mentioned on this board several times, though it's not clear to me exactly how to resolve it. My Samsung WA400PJHDWR/AA will wash small loads without trouble; if they get out of balance and display the "dc" code I can adjust the clothing and the load will finish. But larger loads get out-of-balance frequently, and adjusting the clothing doesn't seem to help. After I adjust the clothing it just goes back into another rinse/spin cycle and never finishes.

I've tried just putting the machine on the "Spin" (only) setting, but apparently the "Spin" (only) setting really means "Rinse + Spin" since it keeps running more water to rinse the clothes. I'd be okay with this if it would ever finish the cycle, but it never does. I end up having to dry dripping wet clothes. 

Any assistance greatly appreciated.

[Anonymous]

We are sorry to hear about this. Please send the model and serial numbers to this PM Link.

[firedog81]

OMG..I cannot get the darn thing to stop rinse/spin, rinse/spin!!!!!!

[userEaWJdPj6Go]

I'm having the same problem.

[userrYDGrTL4Bz]

Having same issue, what is the fix

[SamsungCaleb]

Hey! Thanks for reaching out, can I get you to send me a private message with your model number and serial number?

[userPQ7Y1JjKD9]

I got a Samsung and I have had trouble with it since they installed it too! It takes FOREVER and wastes so much water continuously rinsing over and over and then I can't even open the lid if I want my clothes out because it won't finish I hate it! I wish I bought a simple washing machine and I would have save so much time on top of money