Hi I have dryer dve60m9900v/a3 and on all settings it is stuck at 1 minute, says it’s cooling but is scorching hot. If I’m not paying attention it will run for hours. I tried turning it off from the breakers and cleaning vents bit with no luck.
Hello, I too am having the same issue, with my dryer counting down to 1min and then continuing to run until I manually turn it off. Can someone ease advise on if there is a solution since this seems to be an issue with multiple occurrences.
Hi there! Did any of you fix the "stuck on 1 minute left" problem yet? From what I found I narrowed it down to three potential causes: shortened to the ground heating coil, faulty thermistor or faulty user interface PCB controller. Mine DV42H5000 is doing the same. I do have all spare parts and would like to spend as little time as possible pinpointing to faulty part and replacing it. Any help ranking them from highly possible to rare is appreciated.
Our Samsung dryer is only two years old. When the drying cycle ends, it continues to spin without heat. (It is not on Wrinkle Prevent). The only way to stop it is to open the door. If it is powered off, and we shut the door, it continues to spin without heat.
I have disconnected the power. I have unplugged the mother board. Continues to spin if the door is shut, even if the power is off.
This is something that will require service and I would be delighted to look into this for you. Please send me a private message with the full model and serial number. http://bit.ly/2sSxapD
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
I have the same problem. The only way I can stop my dryer to stop spinning is when I unplug it. If it is plugged in, it just keeps on spinning with no heat. Is this something common with Samsung?
