- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday in
Kitchen and Family HubGreetings, I opted for the Samsung Suite when I built my house in 2017. Since then, I've replaced the microwave and cannot resolve the lc issue. I've cleaned the filters, made sure all the hose connections don't leak, taken off the bottom pan (no water was present but still getting the il code), cleaned the probes on the leak sensor, none of these options clear the error code. I've seen lots of suggestions on removing the pan and wiping up any water, but there wasn't any in mine. I've not seen anyone online who has performed all of these suggestions and still gets the lc error. Help! Am I looking at a new dishwasher in my future? I appreciate any help at this point. Thanks in advance!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday (Last edited yesterday ) in
Kitchen and Family HubDo you have a model number for the dishwasher and I would suggest contacting a service center to have it checked it could be a sensor or something causing the error code
https://www.samsung.com/us/support/service/locations/
If you've found my post to be helpful, Please like my Comments āāā.
If my response resolved your issue, please press the Like and āāā to Accept as Solution button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday in
Kitchen and Family HubSorry, should've included it on my original post. The model number is DW80M9550UG
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday in
Kitchen and Family HubIt sounds like the sensor has gone bad and not resetting I would suggest contacting support and see if itās available
If you've found my post to be helpful, Please like my Comments āāā.
If my response resolved your issue, please press the Like and āāā to Accept as Solution button.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday in
Kitchen and Family HubThanks Gary. If you're referring to the leak sensor, this unit's sensor is not the standard white block with the 4 wires. This model's sensor is smaller and black. The only replacement is the wiring harness itself (it has the probes already attached) and I've checked the existing harness for continuity. I'll call the closest service center in the AM. Thanks again!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yesterday in
Kitchen and Family HubSorry I must of had the wrong model pulled up yeah in the diagram im looking at now I don't see that sensor listed so the best choice would be to contact the service department
If you've found my post to be helpful, Please like my Comments āāā.
If my response resolved your issue, please press the Like and āāā to Accept as Solution button.

