- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2022 07:54 AM (Last edited 06-25-2022 08:03 AM ) in
Monitors and MemoryHello,
My LC49HG90DMLXZS is unusable. At power up it shows a black screen and then vertical colored lines (photo attached). The fault manifests itself even with no video input connected to the monitor.
The installed firmware is m-HG949CCAA-1021.0 downloaded from:
https://www.samsung.com/mx/support/model/LC49HG90DMLXZX/
Please guide me how to solve my problem
Greetings, Marcelo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2022 07:57 AM in
Monitors and MemoryIf you try to bring up the on screen menu built into the monitor how does it look?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2022 08:27 AM (Last edited 06-25-2022 08:28 AM ) in
Monitors and MemoryIndeed, the problem was generated after installing the new firmware.
I can't go back to a previous version because the screen menu built into the monitor is not visible.
I have two identical monitors. I updated the firmware on both and only one has the problem (photo).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2022 11:01 AM in
Monitors and Memory- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2022 08:22 AM in
Monitors and MemoryI can't roll back because the screen menu is not visible.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-12-2022 05:26 PM in
Monitors and MemoryDid you ever get to solve this issue? I have a similar model LC49HG90DMLXZX and the same issue happened out of nowhere, i didn't upgrade the firmware or anything it just happened.
Sometimes i have to wait 15 minutes (or upto 40 minutes if i'm using the DisplayPort) in order for the screen to "clear" itself and see the content again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
09-14-2022 01:59 PM in
Monitors and MemoryHello! I understand how this can be frustrating with your monitor having this display issue. Since this is occurring I would recommend making sure if possible that the firmware is up to date. If that does not help then this will require service. You will have a couple of options based on your warranty.
- If your unit was recently purchased, you can check with your retailer on their return/exchange processes.
- If you have an extended warranty you can reach out to them to have service set up.
- If you're within the one year warranty, you can Private message me or one of our moderators or you can call in directly at 1-800- 726-7864 with your full model and serial number to have service setup
- If you're OUT of warranty, you can use this link below to find a service center in your area.